Cord Drawn Curtain Tracks Instructions

Cord on overlap master carrier as original.

Cord drawn curtain tracks instructions.

Then feed cord around and over the top pulley g pass cord back through ovelrap master slide. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud. Using a small bit drill pilot holes centered in the slot through the top of the track. Measure also the distance from the floor to the top of the curtain rod.

If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. 2 pull track apart at the centre. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. Next place the rod face down on a flat surface.

Replace sliders at each end. Curtain track features and how to install. First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. Draw the cord until the right hand carrier 1 is as far to the right as possible.

Remove the curtains from the traverse rods so you can access the cording. Once you have worked out were your track is going to go. Remove the curtain rod from the. Holding the cords taut push carrier 2 as far to the left as possible.

Click here for how to mend it. Add those two. To drill holes identify where the holes should be positioned and mark the track. Installing your styletrack curtain track.

If you re removing an old cord you can untie it. Measure the rod s length while it is still on the wall. Tension cord and tie off h. How to fit new cord to curtain tracks take measurements.

Place pulley 2 onto track section and secure with screws. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. Hook cord over the lug on carrier 2 to secure it. How to thread cord on curtain rails.

Standard drill bits work fine on all aluminum tracks. 3 unhook cord from master carrier and allow to drop inside track. Then remove master carrier from the track.